PH-3100A Fast Efficient Pre-heater：Product's Details

This pre-heater uses 400W IR or 2×200W IR heaters and closed - loop control to enable fast and safety manual soldering. It is designed for multilayered PCB under Lead-free solder with large heat sinks.

• Total 400W IR of Heating Power - Ensures the heat is saturates evenly and smoothly over multilayered PCB allowing for fast manual soldering.
• PCB holders and Bottom-side Supports Included - Allows for set up and use set for preheating without the need for additional purchases of accessories.
• Wide Area Heating Design - The large area heating design helps prevent the board from warping due to uneven heating.
• This pre-heater is also designed for use with the Den-on SD-3000 II Spot Convection SMT Rework Machine. See www.denondic.co.jp for details.